Loader Backhoe RoadHogs

RH4075-450x350Our family of tractor loader backhoe RoadHogs offers high production at a substantially lower cost than a traditional dedicated milling machine in many applications. These machines are widely used around the U.S. and abroad for small to medium sized milling projects, which include milling city streets prior to overlay and in-place recycling of parking lots.

Utility and pipe contractors also use these self-contained milling machines to open trenches prior to repairing or replacing gas, water or sewer lines at a higher production rate and lower cost per foot versus traditional walk behind saws. Another advantage of using a RoadHog in this application is that each side of the trench is cut simultaneously while the pavement is recycled on site thus eliminating the need to load and truck the material to be recycled elsewhere at a fee. The savings in labor and fuel along with the material, which can be used immediately for backfill, will directly impact job profits.

Municipal customers include cities, townships, counties and state agencies engaged in milling, utility work, recycling, reclamation and stabilization of roads in their area. Many of the projects outsourced to milling and stabilizing contractors can now be performed in house, saving thousands in tax dollars with a tractor loader backhoe RoadHog.

Tractor loader backhoe RoadHogs are offered in cutting widths of 30 and 40-inches. Power comes from a 74hp Cat C3.4 T4F turbocharged diesel engine. Power is transferred to the drum via a belt drive and planetary reduction gearbox, which efficiently provides maximum torque under load. A wireless handheld remote controller (standard equipment) enables the loader operator or ground man to control the drum depth, slope and lateral position within the path of cut providing maximum machine control & safety from any vantage point.

All RoadHogs utilize a ground-engaging frame, which provides accurate depth of cut control; otherwise known as controlled depth milling. In simple terms, the frame is in contact with the ground during the cutting operation and the drum moves up and down within this frame giving the operator the ability to maintain a depth of cut that is typically +/- 3/16-inch. Total depth of cut ranges from 0 to 8-inches.

Cross slope, or tilt, is another important feature of the RoadHog. Slope and drainage characteristics may be re-established on existing or new pavements and base by hydraulically adjusting the angle of the drum +/- 5 degrees.

This combination of finite cutting depth and slope control saves on material costs and ultimately provides a better finish.

Contact us or your dealer for a demo today.

Download the tractor loader backhoe RoadHog brochure